Assembly Instructions
1. Slip one end of the silicone air
hose onto air hose connector of airbrush and the other end onto the air outlet
on the compressor. Plug one end of the power cord into the compressor
and the other end into your wall outlet. Green indicator light
will signal when it's ready for use. This will take several
seconds.
How to
Place compressor on a firm surface such as
your bathroom vanity.
2. Pull protective cap off airbrush tip and pop cap off of airbrush bowl.
3. It is helpful to spray water through
airbrush before beginning each airbrush session. Then place 2 pumps of
AirPro Makeup foundation into the airbrush cup for a light to medium application
on face and neck. Use 3-4 pumps for full coverage of face and chest.
A drop of water can be blended with AirPro foundation in bowl for an ultra sheer
finish.
4. Start compressor by
depressing the red on/off button.
5. Hold airbrush horizontally 3-4 inches
from skin in the same manner that you would a
pencil and pull back the airbrush lever allowing the foundation to flow through
airbrush and onto the skin. You will feel a fine mist of moist air on the
skin. This is a combination of air and foundation being applied to the skin as
tiny dots of pigment, allowing your natural skin tones to show through creating
the appearance of wearing no makeup at all.
EYE AREA: Gently close eyes without squeezing tightly. Airbrush under closed eye
on eyelid and even over lashes to plump them up. You may find it necessary
afterwards to dab around eye area with a damp cosmetic sponge or your finger to
smooth any creases.
CAMOFLAGE: For blemishes and scars hold airbrush approximately 1/2 inch from
spot and gently pull back lever releasing a small amount of foundation.
6. VERY IMPORTANT: After completing the
application remove any excess foundation from the airbrush cup by rinsing with
water. Fill bowl with 4-5 drops of
airbrush cleaner and run through the system until all traces
of foundation are removed.
Tips
The key to achieving a natural yet
flawless look is to keep the airbrush moving at all times. Don't build up
the makeup in one area - go over the entire face several times - - slowly - -
creating an even appearance. Remember to keep the airbrush moving and
you'll soon see an overall smooth appearance without actually seeing the
foundation on the skin.
*Add a pump of Luminizer to
your foundation to highlight top of cheekbone. Add a pump of foundation several
shades darker than your skin tone under cheekbone and forehead to add warmth and
dimension.
Troubleshooting
Airbrush will not spray:
1)Most likely the nozzle is clogged which can happen over time. To
clean, remove handle and needle and carefully lay aside. Next, remove
complete head assembly and soak it in either airbrush cleaner or isopropyl
alcohol. If in a hurry a small oral brush dipped in cleaner or alcohol can
be used to gently clean tip but caution must be used so as not to damage nozzle
tip. Carefully reassemble airbrush.
2)Foundation may be too thick which can happen when the water evaporates
from it over time. Try adding a drop or two of water to foundation and mix
with brush before spraying.
3)Make sure none of the parts are loose.
4)Nozzle or needle may be damaged and need to be replaced.
Airbrush Assembly
1. Screw on, then tighten the
complete head assembly.(50-0161MU)
2. Insert the needle making sure trigger is in proper place and slowly
push all the way forward.(50-0141MU)
3. Screw on the needle chuck and tighten securely.(51-010)
4. Attach the handle(50-033B)
